REVERSE SWEEP ROAD BROOM
The 7301, 7302, 7303 and 7304 "RW" series Reverse Sweeping Bucket Brooms couple to the existing quick hitch on your loader and uses the auxiliary hydraulics to drive the brush. Four sweeping widths are available; 1600mm (7301), 1700mm (7302), 1800mm (7303) and 2000mm (7304), and all buckets are fitted with a bolt-on cutting edge.
The "RW" series of bucket brooms are
recommended for working with a profiler (also called a cold planer), or in conditions where the material to be collected is
thick, heavy or wet. The opened brush face can push down into uneven surfaces and move the material onto a level surface where it
can be picked up cleanly by the bucket broom.
For optimum sweeping efficiency, it is recommended that you reverse when sweeping. A 50/50 mixture of 500mm (20") outside diameter poly and wire brush segments are supplied as standard although this ratio can be altered to suit your application. If desired a solid brush can be fitted to your bucket broom.
Turning the adjustment bolts located on each side of the bucket controls brush contact. The main brush is driven directly off the hydraulic motor via a urethane-coated drive coupling, thereby eliminating chain and sprockets wear parts.
(This broom is also available in chain drive – with motor contained within the bucket lid).
MAXIMUM INTERMITTENT PRESSURE: 207 bar (3000 PSI)
OPERATING FLOW RATE: 35 - 90 l/min (10 - 24 GPM)
APPROXIMATE BUCKET CAPACITY: 0.23 cubic metres